Specifics and Advantages of Flexible Topological Any Angle Routing Agenda:
There are four ways to increase the density of interconnections and component assembly on printed circuit boards:
- Decrease the size of vias and pads to make some room for wire routing
- Increase the number of routes between vias by decreasing wire widths and clearances
- Replace through vias with blind and buried vias
- Add more layers
All of this, however, brings up the board production costs. But there is another way: flexible topological any-angle routing, as implemented in the TopoR (for TOPOlogical Router) PCB topology design system.
To learn more visit our booth 1938 at DAC 2013 Show.
3 June – 5 June 2013. Booth 1938, DAC 2013, Austin Convention Center. 500 East Cesar Chavez Street, Austin, TX 78701, USA
Presentations start every hour!
DAC Floor Plan
DAC official web-site